Wood Saw Blade / Ripping
Ripping—cutting along the grain—places fundamentally different demands on a saw blade than crosscutting. The blade must handle sustained cutting forces, evacuate large chips efficiently, resist heat build-up from prolonged tooth contact, and stay stable under the lateral pressure of a full-depth rip cut.
For multi-rip and gang rip applications, every fraction of a millimetre saved in kerf width translates into extra boards per cant. This category covers anti-kickback single rip saw blades for workshop use, general-purpose and specialty gang rip saw blades with rakers for production lines, and ultra-thin kerf multi-rip configurations that maximise timber yield on high-value runs.
Single-Blade Ripping
For ripping solid wood on table saws and sliding table saws where a single blade handles the full width of a board. Anti-kickback limiter geometry keeps the cut stable and safe, while the rip-optimized tooth form maintains clean exit faces without burning.
Single-Blade Rip / Anti-Kickback
Anti-kickback circular saw blade for safe, stable ripping of softwood and hardwood. Limiter geometry reduces the risk of blade grab, making it suitable for workshop ripping on table saws and sliding table saws.
Gang Rip / Multi-Rip
Multi-rip and gang rip circular saw blades with raker teeth for stable simultaneous ripping of solid wood into multiple boards in a single pass. Includes a general-purpose blade, a shoulder thick-kerf blade for the outer arbor positions, and a variant built for the demanding conditions of wet or resin-rich softwood.
Gang Rip / General Purpose
General-purpose multi-rip circular saw blade with rakers for stable solid wood cutting on gang rip lines. Balanced gullet design handles both softwood and hardwood at standard feed rates.
Gang Rip / Shoulder Outer Position
Thick-kerf shoulder blade for the outer positions of multi-rip arbors. The wider kerf shoulder absorbs lateral cutting forces on the outside boards, improving overall stack stability and cut quality.
Gang Rip / Softwood & Wet Wood
Built for stable multi-rip cutting of wet softwood and resin-rich wood. Tooth geometry and gullet volume optimized for chip evacuation in green or wet timber conditions where resin loading is a persistent problem.
Thin-Kerf Gang Rip
When raw material cost is high and board recovery rate directly affects profitability, thin-kerf and ultra-thin-kerf multi-rip blades deliver a measurable yield advantage. Precision body tensioning maintains lateral stability and tracking at reduced plate thickness, making these blades viable on automated gang rip lines without sacrificing cut straightness.
Gang Rip / Thin Kerf High-Yield
Thin-kerf multi-rip blade with rakers engineered for higher material yield and cleaner chip control. Each millimetre of kerf reduction translates directly to extra boards per cant—critical on high-value hardwood runs.
Gang Rip / Ultra-Thin Kerf Maximum Yield
Ultra-thin kerf multi-rip blade for maximum material yield and minimum sawdust loss. Built to sustain body stiffness and tracking stability at ultra-thin plate thickness through precision tensioning and slot geometry.
Share your timber species, moisture content, arbor configuration, number of blades, target board thickness, and current problems—burn marks, blade drift, excessive sawdust loss, or kickback. We will recommend the right ripping saw blade or gang rip configuration for your production line.
We use cookies to enhance your browsing experience, analyze site traffic, and support our marketing. By clicking “Accept”, you consent to our use of cookies. Read our Privacy Policy.